General Pump - Clutch Adapter Single Groove Kit For 47 Series Pumps

In typical water pump applications, the clutch is mounted on the input shaft of the water pump. Since the clutch has an integral pulley, a belt is used as the input to the clutch. This belt is normally driven directly from an electric motor or a gas/diesel engine. When there is no power to the clutch, the water pump does not not engage; however when power is activated, the clutch drives the water pump to initiate water flow. In this application, the GP clutch is mounted directly to a General Pump by using an adapter plate.

• Extended pump life
• Less Cost
• Simple installation
• Operator convenience
• Cold weather starting

• Solid forged rotor.A one-piece solid forged rotor means no chance of internal parts separation. They have an
even wall thickness around the coil which gives optimum flux distribution, maximizing torque.

• High temperature, longer-life grease. Our special long-life grease has shown a significant improvement in life
over other standard high temp greases

• High-temperature epoxy coil. To help prevent failure from vibration and outside contaminants, all coils are
sealed in the coil shell with a high-temperature epoxy coating.

• Forged machined pulley. All GP models use a heavy-duty machined pulley. A stronger pulley resists damage
due to abusive environments.